Getting setup out of the box with the entire Gizmo platform is a relatively straightforward process. In general, here’s what you’ll need to do:
Assemble the Gizmo
The Gizmo itself requires minimal assembly. You’ll need to install both processors which involves pressing them into the sockets on the board. With the board facing you (text where you can read it) install the Raspberry Pi Pico WH on the left side (the WH is the one with the metal square at the bottom).
Install the Raspbery Pi Pico H on the right side in a similar fashion. It helps to press down with both thumbs equally at the top and bottom of the Pico to ensure it goes in smoothly. Be careful doing this on top of a surface that can be scratched, as the pins that stick out of the bottom of the board can scratch soft surfaces.
Once you’ve installed the processors, we recommend putting your Gizmo in a suitable enclosure to protect it from physical damage. Here’s one you can make with a 3D Printer.
You’re now ready to install your Gizmo on a robot or other device and write some software to make it do something! Information about programming the Gizmo is available in the manual.
Assemble the Driver’s Station
The driver’s station needs to be physically assembled, then software installed. You can find full information on how to do this in the manual.
Assemble the FMS (Competition Only)
You only need to assemble the FMS if you’re running a competition. This is a fairly involved process, so consult the manual and don’t be afraid to ask for help if you need it.